There
is a choice between vertical horizontal and cylindrical
bulk milk coolers. Each better than the other because
they are lightweight, fast cooling & extra tough.
The inner vessel and other casing of each cooler in
AISI 304 stainless steel (trans cold prime surface heat
transfer incorporator for thermal efficiency is also
provided). The vertical open tank has an angled bottom
ensures complete empty tip. Its specialties one thick
insulation, internal ball seal, DN 50 threaded outlet
with plastic caps. The horizontal open type tank has
cover with a retainer for open type tank has cover with
a retainer for open position and two-food type plastic
lid for milk feeding the drain cock is supplied with
wing type DN50 safety release.
The cylindrical closed type tank has a manhole type
close fitting covers for thick insulation. The environmentally
safe polyurethane form is used. It has a DN50 butterfly
valve outlet.
All the refrigeration plant have direct expansion, no
freezing at low fill levels, R22 coolant and performance
as per ISO 5708 class 2 A / V standards
Very
high output DIMPLED TRAPCOLD EVAPORATOR. This
evaporator is characterized by a high THERMAL
EXCHANGE coefficient, which leads to,
A) A quick
refrigeration speed
B) Small differences in temperature between the
milk & the evaporator
especially at the end of the refrigeration, thus
preventing ice form forming.
C) A reduced surface, making it easy to use at low
filling level.
D) A reduced energy consumption. Ø Stainless
steel outlet butterfly valve.
Excellent
insulation of green polyurethane foam (CFC Free).
Stainless
steel dipstick with calibration chart to measure
the milk quantity.
Generously
sized work platform providing access to manhole
without ground support provided with handrails,
hence making cleaning very easy.
AISI 304
manhole, LID is without gasket and is tight.
Cooling
Equipment
High
cooling performance as per ISO 5708 CLASS 2A II,
2 means 2 milking
A means ambient temp.
of 38° C
II means cooling within
3hrs. from 35° C to 4° C for all milking
and within 1.5 hrs. from 10° C to 4° C for
second milking.
Safe operating temperature
is 43° C
Direct expansion.
Expansion valve and
liquid receiver.
Hermetic type compressors
working with R22.
Compact mounting.
Electrical Equuipment
The
regulation of cooler is ensured by an electromechanically
thermostat, a DIA. 60 MM thermometer and an electromechanical
agitation programmer.
Compact electromechanically
control panel to control the operation of the unit
such as cyclic agitation of agitator and cooling
cycle.
